For example, I am using a RPI3+ B with 1GB RAM and a 8GB SD card.
#Zoiper sipcall how to#
For example, I am not interested in Wifi, Fax, Mail, or how to configure trunks to North American VOIP providers, and I also have not followed all the Incredible PBX recommendations as I’m only doing proof of concept. The Nerdvittles has a lot of excellent information, but a lot of that information I am not using. You should find everything you need here –, and here “ ” (at the time of writing, the exact “Nerdvittles” tutorial is documented in the “” link above).
#Zoiper sipcall install#
The first thing to do is to buy the right equipment and install the base system. Interactive Voice Response (IVR – “press 1 for English, drücken Sie 2 für Deutsch….”) How to trunk to potential Internal PBX’s (e.g.
The scope is to explain how to connect handsets to a PBX to make internal and external calls. The scope of this document is basically mentioned in the Introduction. The VOIP provider(s) will also route all outbound calls to external telephone numbers. The VOIP provider(s) will route all inbound calls for your telephone number(s) to your PBX, and the PBX will then route the call to a local handset(s)/softphone(s). The following picture shows the setup I am documenting in this blog.
What I’m writing here is relevant for all flavours of Asterisk/FreePBX based PBX’s. Although I’ve installed Incredible PBX (also known as PBXinaflash), there are many flavours of Asterisk/FreePBX based PBX’s that can be installed on many hardware platforms. For my proof of concept I’ve used a Single Board Computer (my SBC is a Raspberry PI 3B+) with Incredible PBX installed on the Raspberry PI. This blog is a good place to start if you’re just starting out with VOIP and want to run your own PBX, but note very well that it is just a getting started guide! This blog focus’s on how to setup a single PBX with two public telephone numbers that one can route to handsets (generally soft-phones on one’s mobile phones) for incoming calls, and for handsets to be able to make outgoing calls or internal calls whether those handsets are connected to the PBX internally or externally.
0 kommentar(er)
